Kwik-Clean – Flux & Patina Remover
16 oz. (450 ml) Spray Bottle
ELIMINATES ‘WHITE MOLD’ Caused by Flux & Patina being left behind.
Never…ever… use WATER to wash off your glass project.
Just Spray on Kwik-Clean & Wipe Off!
Just spray on Kwik-Clean after soldering to clean off the flux. Or spray on Kwik-Clean after applying patina to neutralize and clean up the left-over patina. No water is required for cleaning the window.
No need to mix or dilute. After you have completed soldering one or both sides of your project, spray on Kwik-Clean. Typically, with a paper towel clean project thoroughly.
You may use the same paper towel or a clean one to apply the patina. Mixing the Kwik-Clean with the Patina gives added cleaning of the flux and a finer tone on the patina.
After Patina is applied, clean again with Kwik-Clean.
Polish as you normally would.
On pieces where White Mold is already present:
For problem climates where White Mold is rampant. Steel wool after the first Kwik-Clean and before the Patina assures a finer clean of flux from under the foil. Then apply your patina & clean again with Kwik-Clean.